What requirements must be met for adhesive mixtures in a dry state?
The moisture content of adhesive mixtures should not exceed 0.30% by weight
The bulk density of the adhesive mixture should not exceed 1600 kg/m3
The largest grain size of the adhesive mixture should not exceed 0.63 mm.
The content of grains larger than 0.63 mm in the adhesive mixture should not exceed 0.50%
The amount of cement in the adhesive mixture must exceed 35% of the mass
The specific effective activity of natural radionuclides of adhesive mixtures should not exceed the limit values established by GOST 30108
Material on this issue is presented in the GOST R 56387 .
What requirements must be met for adhesive mortar mixtures (ready-to-use)?
The average density of adhesive mortar mixtures must exceed 1800 kg/m3
The water-holding capacity of ready-to-use adhesive mortar mixtures must be at least 98%
The average density of adhesive mortar mixtures is set by the manufacturer at the request of the consumer
Resistance to slipping of adhesive mixtures is characterized by the value of displacement under the influence of gravity of facing tiles laid on a vertical or inclined surface. For adhesive mixtures, the offset value should be no more than 1.5 mm.
Resistance to slipping of adhesive mixtures is characterized by the value of displacement under the influence of gravity of facing tiles laid on a vertical or inclined surface. For adhesive mixtures of class T, the displacement value should be no more than 0.5 mm, for mixtures of other classes - no more than 0.7 mm.
The water-holding capacity of adhesive mortar mixtures, ready for use, must be at least 85%
Adhesive mixtures must comply with the requirements of the GOST R 56387 standard and be manufactured according to technological documentation approved by the manufacturer. The main indicators of the quality of adhesive mixtures in the hardened state are ...
Open time
Strength of the adhesive bond (adhesion) after exposure to an aqueous environment
Strength of the adhesive bond (adhesion) after exposure to an air-dry environment
Strength of adhesive bond (adhesion) after exposure to high temperatures
Wetting ability
Transverse deformation
Strength of adhesive bond (adhesion) after cyclic freezing and thawing
To mix (dilute, mix) cement adhesive mixtures of class C1, it is necessary to use...
Water latex
Water-based latex mixture
Synthetic oil
Primer
Vegetable oil
PVA - emulsion of polyvinyl acetate in water, with a plasticizer and special additives
Water
Adhesive milk
Material on this issue is presented in technical data sheets for cement adhesive mixtures.
Adhesive mixtures must comply with the requirements of the GOST R 56387 standard and be manufactured according to technological documentation approved by the manufacturer. The main indicators of the quality of adhesive mixtures in a dry state are ...
Largest aggregate grain size
Low dust generation
Color
Content of grains of the largest coarseness
Bulk density
Humidity
