An example of a symbol for an adhesive mixture based on a cement binder, intended for interior and exterior work, meeting increased requirements, with increased resistance to slipping, increased open time and high elasticity.
Dry construction adhesive mixture C2 FE S2, GOST R 56387
Dry construction adhesive mixture C1 FE S2, GOST R 56387
Dry construction adhesive mixture C1 TE S2, GOST R 56387
Dry construction adhesive mixture C1 TE S1, GOST R 56387
Dry construction adhesive mixture C2 TE S1, GOST R 56387
Dry construction adhesive mixture C2 TE S2, GOST R 56387
Material on this issue is presented in the GOST R 56387 .
The terms with their corresponding definitions are listed below. Indicate those for which the match is correct.
Sliding is the displacement under the influence of gravity of tiles or slabs laid on a layer of mortar mixture treated with a notched trowel applied to a vertical or inclined surface.
Holding time after preparation is the maximum period of time during which a freshly prepared mortar mixture (after additional mixing without adding water) retains its technological properties.
A notched trowel is a toothed tool that allows you to create a layer of mortar mixture on the base in the form of grooves of the same thickness.
Open time - the maximum period of time after applying a layer of mortar mixture of a given adhesion strength to the base on the base, during which it is allowed to lay facing tiles on the applied mortar mixture.
Adhesion is the ability of a layer of mortar mixture treated with a notched trowel to wet the facing tile.
Pot life is the period of time after mixing the mortar mixture necessary to achieve readiness for installation.
Material on this issue is set out in the GOST R 56387 .
The symbol of adhesive mixtures must consist of the name of the mixture in accordance with GOST 31189, class designation, values of basic quality indicators (if necessary) and standard designation. Adhesive mixtures are divided into the following classes...
C2 - used for interior and exterior work and meeting increased requirements
E – mixtures with increased resistance to slipping
S1 – highly elastic mixtures
T – quick-hardening adhesive mixtures
F – mixtures with extended open time
C0 – used for laying tiles with normal water absorption (at least 5% by weight) only for interior work
S2− elastic adhesive mixtures
C1 – used for interior and exterior work and meeting the minimum regulated requirements
Adhesive mixtures must comply with the requirements of the GOST R 56387 standard and be manufactured according to technological documentation approved by the manufacturer. The main indicators of the quality of adhesive mixtures in the hardened state are ...
Transverse deformation
Strength of adhesive bond (adhesion) after cyclic freezing and thawing
Strength of adhesive bond (adhesion) after exposure to high temperatures
Wetting ability
Strength of the adhesive bond (adhesion) after exposure to an air-dry environment
Open time
Strength of the adhesive bond (adhesion) after exposure to an aqueous environment
Adhesive mixtures must comply with the requirements of the GOST R 56387 standard and be manufactured according to technological documentation approved by the manufacturer. The main indicators of the quality of adhesive mixtures in a dry state are ...
Content of grains of the largest coarseness
Humidity
Low dust generation
Color
Bulk density
Largest aggregate grain size
