Adhesive mixtures must comply with the requirements of the GOST R 56387 standard and be manufactured according to technological documentation approved by the manufacturer. The main indicators of the quality of adhesive mixtures in a dry state are ...
Humidity
Color
Bulk density
Content of grains of the largest coarseness
Largest aggregate grain size
Low dust generation
Material on this issue is presented in the GOST R 56387 .
What requirements must be met for adhesive mixtures in a dry state?
The largest grain size of the adhesive mixture should not exceed 0.63 mm.
The amount of cement in the adhesive mixture must exceed 35% of the mass
The content of grains larger than 0.63 mm in the adhesive mixture should not exceed 0.50%
The moisture content of adhesive mixtures should not exceed 0.30% by weight
The bulk density of the adhesive mixture should not exceed 1600 kg/m3
The specific effective activity of natural radionuclides of adhesive mixtures should not exceed the limit values established by GOST 30108
To mix (dilute, mix) cement adhesive mixtures of class C1, it is necessary to use...
Adhesive milk
PVA - emulsion of polyvinyl acetate in water, with a plasticizer and special additives
Water
Vegetable oil
Primer
Water latex
Synthetic oil
Water-based latex mixture
Material on this issue is presented in technical data sheets for cement adhesive mixtures.
The terms with their corresponding definitions are listed below. Indicate those for which the match is correct.
Open time - the maximum period of time after applying a layer of mortar mixture of a given adhesion strength to the base on the base, during which it is allowed to lay facing tiles on the applied mortar mixture.
A notched trowel is a toothed tool that allows you to create a layer of mortar mixture on the base in the form of grooves of the same thickness.
Sliding is the displacement under the influence of gravity of tiles or slabs laid on a layer of mortar mixture treated with a notched trowel applied to a vertical or inclined surface.
Pot life is the period of time after mixing the mortar mixture necessary to achieve readiness for installation.
Adhesion is the ability of a layer of mortar mixture treated with a notched trowel to wet the facing tile.
Holding time after preparation is the maximum period of time during which a freshly prepared mortar mixture (after additional mixing without adding water) retains its technological properties.
Material on this issue is set out in the GOST R 56387 .
The symbol of adhesive mixtures must consist of the name of the mixture in accordance with GOST 31189, class designation, values of basic quality indicators (if necessary) and standard designation. Adhesive mixtures are divided into the following classes...
T – quick-hardening adhesive mixtures
S1 – highly elastic mixtures
E – mixtures with increased resistance to slipping
S2− elastic adhesive mixtures
F – mixtures with extended open time
C1 – used for interior and exterior work and meeting the minimum regulated requirements
C0 – used for laying tiles with normal water absorption (at least 5% by weight) only for interior work
C2 - used for interior and exterior work and meeting increased requirements
